Plastic 3D printed end caps are provided with the kit to simplify mechanical construction. The kit builder installs the 8 surface mount parts, the SA818 radio module and completes final mechanical assembly. The kit is supplied with all of the small surface mount parts installed on the PC board. The SHARI kit contains all of the parts required to build the device. The circuit board contains surface mount (SMD) parts as well as 8 through-hole parts and the SA818 radio module. Radio settings changed using a program running on the Raspberry PiĪ comparison matrix of the specifications and features of SHARI, BRIAN(SM) and DINAH can be downloaded by clicking on the DOWNLOAD button below.ĭINAH-BRIANSM-SHARI-Comparison-Matrix-11-9-20 Download Schematic SHARI Schematic Rev C Parts List SHARI Kit Contents Construction.3D printed plastic end caps with all required holes provided.Kit builder installs 8 through-hole parts, the radio module and completes final mechanical assembly.Kit includes PCB with all surface mount parts installed.Small, portable with self contained radio and antenna.about 400 – 500 milliwatts RF output power.Uses a NiceRF SA818 UHF or VHF embedded radio module.
Uses the Cmedia CM119B or CM108B USB audio IC.Works with a Pi3 or Pi4 ( USB connector positions swapped).Note that the two male USB plug locations are switched between the Pi3 and Pi4 models of SHARI so that access to the Ethernet jack on the Raspberry Pi is not blocked. SHARI RF output power is around 400 to 500 milliwatts. In order to create an Allstar node, SHARI plugs into two USB jacks on a Raspberry Pi3 or Pi4 for power, the Allstar interface and radio programming (a short M/F USB extender cable can be used if desired).įour front panel LEDs indicate the status of SHARI –.
0 kommentar(er)
